基于悬臂梁流变试验的倾倒变形力学特性分析

郑达; 苏杭; 庞波

doi:10.3969/j.issn.0258-2724.20190478

基于悬臂梁流变试验的倾倒变形力学特性分析

doi: 10.3969/j.issn.0258-2724.20190478

基金项目: 国家重点研发计划（2018YFC1504905）；国家自然科学基金（41772317）

详细信息

作者简介:
郑达（1977—），男，教授，博士，研究方向为地质灾害评价防治及高边坡稳定性，E-mail：zhengda@cdut.cn

中图分类号: TU 443
计量
- 文章访问数: 586
- HTML全文浏览量: 329
- PDF下载量: 12
- 被引次数: 0
出版历程
- 收稿日期: 2019-05-29
- 修回日期: 2019-12-12
- 网络出版日期: 2020-01-24
- 刊出日期: 2020-10-01

Mechanical Characteristics Analysis of Toppling Deformation Based on Rheological Tests for Cantilever Beam

摘要

摘要: 弯曲倾倒变形本质是岩层所发生的弯曲流变变形，为了阐明其时效特点与力学特性，首先对反倾层状斜坡进行受力分析，将岩层某点的受力简化为自重应力与水平侧应力；其次在该受力条件下，进行了悬臂梁弯曲流变试验，将岩层悬臂式弯曲流变模型概化为4个阶段：瞬时变形阶段、衰减蠕变阶段、稳态蠕变阶段、加速蠕变阶段. 基于上述的试验和分析，推导出悬臂梁弯曲流变的本构方程；并选取岩梁发生倾倒变形时极限位置处应变为0，对本构方程进行求解得出倾倒变形发育的极限深度；以悬臂梁倾倒折断时应变加速度等于稳态蠕变的上限加速度为求解条件，得出岩梁的倾倒折断深度.
- 倾倒变形 /
- 力学特性 /
- 悬臂梁流变试验 /
- 倾倒发育深度 /
- 倾倒折断深度
Abstract: Curved toppling deformation is essentially the rock rheological deformation. In order to clarify its time-dependent characteristics and mechanical properties, the force analysis of anti-dip stratified slope is conducted, in which the force at a certain point of the rock layer is simplified as the gravity stress and horizontal stress. Then, the rheological tests of the bending cantilever beam are performed under this stress condition. The rheological model of the bending cantilever for rock strata is generalized as four stages: instantaneous deformation, attenuated creep, steady creep and accelerated creep. Based on the above tests and analysis, the constitutive equation for the rheological deformation of the bending cantilever beam is deduced. Through the calculation of the equation, assuming that the strain at the position of the ultimate toppling deformation of rock beam is zero lead to the ultimate depth of the toppling deformation. Given that as the beam breaks the strain acceleration is equal to the upper limit acceleration of the steady creep, the toppling fracture depth can be obtained.
- toppling deformation /
- mechanical characteristics /
- cantilever rheological test /
- toppling depth /
- toppling fracture depth

HTML全文

图 1 斜坡力学模型

Figure 1. Slope mechanical model

下载: 全尺寸图片幻灯片

图 2 岩层受力分析示意

Figure 2. Force analysis of rock layer

下载: 全尺寸图片幻灯片

图 3 流变试样示意

Figure 3. Sample of rheological tests

下载: 全尺寸图片幻灯片

图 4 悬臂梁流变试验示意

Figure 4. Rheological test of cantilever beam

下载: 全尺寸图片幻灯片

图 5 试验中岩梁弯曲变形（1# 梁）

Figure 5. Baending deformation in test (1# beam)

下载: 全尺寸图片幻灯片

图 6 1# 梁流变曲线

Figure 6. Rheological curve of 1# beam

下载: 全尺寸图片幻灯片

图 7 1# 梁流变速率曲线

Figure 7. Rheological velocity curve of 1# beam

下载: 全尺寸图片幻灯片

图 8 第5级荷载作用时试样应变速率

Figure 8. Strain rate under the fifth stage loading

下载: 全尺寸图片幻灯片

图 9 应变加速度曲线

Figure 9. Strain acceleration curve

下载: 全尺寸图片幻灯片

图 10 经玻尔兹曼原理叠加后的流变曲线

Figure 10. Rheological curve after superposition by Boltzmann principle

下载: 全尺寸图片幻灯片

图 11 加卸载流变试验曲线

Figure 11. Loading and unloading curve in rheological tests

下载: 全尺寸图片幻灯片

图 12 流变模型示意

Figure 12. Rheological model

下载: 全尺寸图片幻灯片

图 13 1# 梁拟合曲线

Figure 13. Fitting curve of 1# beam

下载: 全尺寸图片幻灯片

表 1 一次加载断裂试验结果

Table 1. Test results for one-time loading to fracture

试样编号断裂荷载/g 最大应变/ × 10⁻⁶

1# 2 675 438
2# 3 175 475
3# 2 675 449
平均值 2 842 454

下载: 导出CSV

表 2 试验加载方案

Table 2. Loading plan of rheological tests

加载级别加载重量/g 试验时间/h

1 1 175 21
2 1 675 48
3 2 175 43
4 2 675 39
5 3 175 40

下载: 导出CSV

参考文献(13)

王军. 黄河拉西瓦水电站坝前右岸果卜岸坡变形演化机制研究[D]. 成都: 成都理工大学, 2011.

杨根兰,黄润秋,严明,等. 小湾水电站饮水沟大规模倾倒破坏现象的工程地质研究[J]. 工程地质学报,2006,14(2): 165-171. doi: 10.3969/j.issn.1004-9665.2006.02.004

YANG Genlan, HUANG Runqiu, YAN Ming, et al. Engineering geological study on a large scale toppling deformation at Xiao Wan hydropower station[J]. Journal of Engineering Geology, 2006, 14(2): 165-171. doi: 10.3969/j.issn.1004-9665.2006.02.004

余鹏程. 澜沧江苗尾水电站坝址区岩体倾倒变形特征及坝肩岩体稳定性分析[D]. 成都: 成都理工大学, 2007.

谢莉. 澜沧江黄登水电站右坝肩2# 变形体成因控制条件及稳定性研究[D]. 成都: 成都理工大学, 2010.

EVANS R S. Analysis of secondary toppling rock failures-the stress redistribution method[J]. Quarterly Journal of Engineering Geology, 1981, 14(2): 77-86. doi: 10.1144/GSL.QJEG.1981.014.02.01

TENE S C, WEST T R. Some secondary toppling failure mechanisms in discontinuous rock slopes[C]//Proc. 24th US Symposium on Rock Mechanics. [S.l.]: Assoc of Engineering Geologists, 1983: 193-204

陈红旗,黄润秋. 反倾层状边坡弯曲折断的应力及挠度判据[J]. 工程地质学报,2004,12(3): 243-246,273. doi: 10.3969/j.issn.1004-9665.2004.03.004

CHEN Hongqi, HUANG Runqiu. Stress and flexibility criteria of bending and breaking in a countertendency layered slope[J]. Journal of Engineering Geology, 2004, 12(3): 243-246,273. doi: 10.3969/j.issn.1004-9665.2004.03.004

张以晨, 佴磊, 沈世伟, 等. 反倾层状岩质边坡倾倒破坏力学模型[J]. 吉林大学学报（地球科学版）, 2011, 41（增刊1）: 207-213.

ZHANG Yichen, ER Lei, SHEN Shiwei, et al. Mechanical models of anti-dip layered rock slope toppling failure[J]. Journal of Jilin University (Earth Science Section), 2011, 41(S1): 207-213.

刘海军, 赵建军, 巨能攀. 岩质边坡倾倒破坏的力学分析[J]. 岩土力学, 2016, 37（增刊1）: 289-294.

LIU Haijun, ZHAO Jianjun, JU Nengpan. Mechanical analysis of toppling failure of rock slope[J]. Rock and Soil Mechanics 2016, 37(S1): 289-294.

黄润秋. 20世纪以来中国的大型滑坡及其发生机制[J]. 岩石力学与工程学报,2007,26(3): 433-454. doi: 10.3321/j.issn:1000-6915.2007.03.001

HUANG Runqiu. Large-scale landslides and their mechanism in China since the 20th century[J]. Journal of Rock Mechanics and Geotechnical Engineering, 2007, 26(3): 433-454. doi: 10.3321/j.issn:1000-6915.2007.03.001

庞波,郑达,黄鹏. 基于流变模型的反倾层状岩体倾倒变形发育深度的力学分析[J]. 科学技术与工程,2016(18): 129-134. doi: 10.3969/j.issn.1671-1815.2016.18.023

PANG Bo, ZHENG Da, HUANG Peng. Geological model analysis on the depth of toppling deformation in the anti-dip rock slopes[J]. Science Technology and Engineering, 2016(18): 129-134. doi: 10.3969/j.issn.1671-1815.2016.18.023

王剑梅. 反倾层状岩体倾倒变形的力学机制分析及其早期识别指标体系研究[D]. 成都: 成都理工大学, 2015

范庆忠,高延法. 分级加载条件下岩石流变特性的试验研究[J]. 岩土工程学报,2005(11): 38-41. doi: 10.3969/j.issn.1000-7598.2005.05.004

FAN Qingzhong, GAO Yanfa. Experimental study on creep properties of rocks under stepwise loading[J]. Chinese Journal of Geotechnical Engineering, 2005(11): 38-41. doi: 10.3969/j.issn.1000-7598.2005.05.004

施引文献

附加材料(0)

访问统计