用于无线通信系统的信号强度检测电路设计

何晓丰; 马成炎; 叶甜春; 甘业兵; 金玉花

doi:10.3969/j.issn.0258-2724.2012.05.011

用于无线通信系统的信号强度检测电路设计

doi: 10.3969/j.issn.0258-2724.2012.05.011

基金项目:

国家重大科技专项项目(2009ZX01031-002-008)

详细信息

通讯作者:
马成炎(1967-),男,研究员,博士生导师,研究方向为射频模拟集成电路设计,E-mail:machengyan@casic.ac.cn

计量
- 文章访问数: 1233
- HTML全文浏览量: 78
- PDF下载量: 455
- 被引次数: 0
出版历程
- 收稿日期: 2011-09-28
- 刊出日期: 2012-10-25

Received Signal Strength Indicator Circuit for Wireless Communication Systems

摘要

摘要: 为了解决传统的信号检测电路准确度不高,对温度和工艺变化抵抗能力不够的问题,建立了信号强度检测电路的系统模型.推导得到限幅放大器增益与信号强度检测单元误差的关系以及降低信号强度检测单元误差的方法.通过分析,得到在提高准确度的前提下减小限幅放大器增益随温度和工艺变化的方法.基于以上分析,引入增益加强结构,以提高限幅放大器增益的准确性和抵抗温度及工艺变化的能力.采用0.18 μm体硅(CMOS)工艺,1.8 V供电电源,面积为500 μm×200 μm的电路进行测试,结果表明:测试温度从-40 ℃变化到85 ℃时,该信号强度检测电路都可以提供55 dB的动态范围和大于55 MHz的带宽,其检测误差小于1.5 dB,电路功耗为1.89 mW,检测精度高达1.5 dB.
- 信号强度检测 /
- 限幅放大器 /
- 检测精度
Abstract: To solve the problems that accuracy of traditional signal strength indicator circuit is low and resistance to temperature and process variations is not enough strong, a system model for RSSI (received signal strength indicator) circuit was set up. The relationship between limiting amplifier gain and signal strength detection unit error was derived, and measures to decrease the error were obtained. Through analyses ways to reduce gain change with temperature and process under the condition of improving accuracy were gained. Based on the analyses, a gain-enhanced structure was introduced to improve the accuracy of limiting amplifier gain and raise its ability to resist temperature and process variations. The designed circuit uses 0.18 μm bulk silicon (CMOS) technology with 1.8 V power supply, and its area is 500 μm × 200 μm. The test results show that the dynamic gain range of the circuit can reach 55 dB while test temperature changes from -40 ℃ to 85 ℃. The circuit can provide a bandwidth greater than 55 MHz and its detection error is less than 1.5 dB. The power consumption of the circuit is 1.89 mW, and its detection accuracy is up to 1.5 dB.
- received signal strength indicator /
- limiting amplifier /
- detection accuracy

HTML全文

参考文献(15)

LEI Qianqian, LIN Min, PENG Miao, et al. A CMOS low power, wide dynamic range RSSI with integrated AGC loop//Proceedings of 2011 IEEE International Conference on Anti-Counterfeiting, Security and Identification. Beijing: IEEE, 2011: 173-176.

XU Hua, SHI Yin, DAI F F. A CMMB mobile TV tuner frontend with integrated RSSI for dual-band applications//Proceedings of IEEE 8th International Conference on ASIC. Changsha: IEEE, 2009: 351-354.

甄志芳,赵毅,张福海. 全集成CMOS限幅器与场强指示器设计[J]. 南开大学学报:自然科学版,2008,32(4): 42-46. ZHEN Zhifang, ZHAO Yi, ZHANG Fuhai. Fully integrated CMOS limiter and RSSI[J]. Acta Scientiarum Naturalium Universitatis Nankaiensis, 2008, 32(4): 42-46.

庄海孝,马成炎,叶甜春,等. CMMB系统中RSSI电路设计[J]. 浙江大学学报:工学版,2011,15(5): 15-18. ZHUANG Haixiao, MA Chengyan, YE Tianchun, et al. Limiting amplifier and received signal strength indicator for CMMB receiver[J].Journal of Zhejiang University: Engineering Science, 2011, 15(5): 15-18.

孙杨,张晓林,夏温博. 用于GPS接收机的CMOS RSSI电路的设计[J]. 遥测遥控,2010,8(5): 12-16. SUN Yang, ZHANG Xiaolin, XIA Wenbo. CMOS RSSI design for GPS receiver[J]. Journal of Telemetry, Tracking and Command, 2010, 8(5): 12-16.

DENG Chen, FANG Yiyuan. Improved RSSI indoor location system based on fuzzy algorithm//Proceedings of 2011 IEEE International Conference on Computer Science and Automation Engineering. Beijing: IEEE, 2011: 255-258.

徐鹏,方旭明,杨俊. 基于信号强度和功率损耗的分层网络切换算法[J]. 西南交通大学学报,2011,46(1): 98-102,108. XU Peng, FANG Xuming, YANG Jun. Handoff algorithm for hierarchical cell networks based on received signal strength and power loss[J]. Journal of Southeast Jiaotong Univercity, 2011, 46(1): 98-102,108.

HU Weiyi, LIN Jiawei, TIEN K C, et al. A 0.18 μm CMOS RF transceiver with self-detection and calibration functions for bluetooth V2.1 EDR applications[J]. IEEE Transactions on Microwave Theory and Techniques, 2010, 58(2): 1367-1374.

李志杰,方旭明. 一种无线多跳网络业务性能跨层优化方法[J]. 西南交通大学学报,2012,47(1), 12-18,31. LI Zhijie, FANG Xuming. Method of cross-layer performance optimization in wireless multi-hop networks[J]. Journal of Southeast Jiaotong Univercity, 2012, 47(1): 12-18, 31.

THE Y J, CHOI Y B, YEOH W G. A 40 MHz CMOS RSSI with data slicer//Proceedings of International Symposium on Integrated Circuits. Singapore: IEEE, 2007: 345-348.

HUANG P C, CHEN Y H, WANG C K. A 2V 10.7 MHz CMOS limiting amplifier/RSSI[J]. IEEE Journal of Solid-State Circuits, 2000, 35(4): 1474-1480.

LEE S H, SONG Y H, NAM S W. Fast RSSI circuit using novel power detector for wireless communication//International SoC Design Conference. Busan: IEEE, 2008: 9-12.

CHEN Yichung, WU Yichang, HUANG P C, et al. A 1.2-V CMOS limiter / RSSI / demodulator for low-iF FSK receiver//Proceedings of IEEE Custom Integrated Circuits Conference California. [s.l.]: IEEE, 2007: 217-220.

王静光,马德群,洪志良. 用于蓝牙接收通道的CMOS限幅放大器和功率指示计[J]. 应用科学学报,2005,23(5): 478-482. WANG Jingguang, MA Dequn, HONG Zhiliang. A CMOS limiting amplifier and received signal strength indicator for bluetooth receiver[J]. Journal of Applied Sciences, 2005, 23(5): 478-482.

CHAO Yang, MASON A. Precise RSSI with high process variation tolerance//Proceedings of IEEE International Symposium on Circuits and Systems. Rio de Janeiro: IEEE, 2007: 2870-2873.

施引文献

附加材料(0)

访问统计

点击查看大图

计量

文章访问数: 1233
HTML全文浏览量: 78
PDF下载量: 455
被引次数: 0

用于无线通信系统的信号强度检测电路设计

doi: 10.3969/j.issn.0258-2724.2012.05.011

通讯作者: 马成炎(1967-),男,研究员,博士生导师,研究方向为射频模拟集成电路设计,E-mail:machengyan@casic.ac.cn

计量

出版历程

Received Signal Strength Indicator Circuit for Wireless Communication Systems

计量

出版历程

目录

通讯作者:
马成炎(1967-),男,研究员,博士生导师,研究方向为射频模拟集成电路设计,E-mail:machengyan@casic.ac.cn